DETAILED DESCRIPTION

1987 HANS CHRISTIAN CUTTER 33T
LOA: 41.0’  LOD: 32.8’  LWL: 30.0’  Beam: 11.6’  Depth: 5.5’

CONSTRUCTION

Hull: Laminated fiberglass. Keel attachment: Encapsulated. Deck material: Fiberglass (not cored) with teak planking. Rudder: Fiberglass with stainless steel stern post. Hull ventilation: Provided by 10 opening bronze ports; two deck hatches; six dorade vents; and companion way. Hull to deck: Stainless steel fasteners with sealant. Overall condition of exterior: Good. Interior: Teak and teak. Floor: Teak and holly sole over stringers.  Hull stringers: Fiberglass.  Bulkheads: Fiberglass, teak and marine plywood with teak laminate.
This hull is overbuilt for offshore use and is a very rigid hull.

ARRANGEMENTS TOPSIDE

Topside and full forward is an electric windless anchor control system. Stainless steel bow pulpit and stern pushpit rails. Double wire lifelines and stanchions forward with two opening gates mid ship, aft are solid upper stainless hand rails. Companion way entry has a canvas dodger. Rigging, mast, boom, halyards, sheets and related hardware are adequate for the vessel and intended use. Decks are clear of obstacles and all sail control lines are routed to the mast and cockpit. Boom is supported by boom gallows and the solar panels have stainless steel supports. Deck box located aft of the anchor windlass on bow.

ARRANGEMENTS BELOW

Anchor chain locker is below decks and full forward. Entry is via two doors in head. Head has Lavac toilet; sink; and separate shower stall. Large double or small queen berth to port with large hanging locker to starboard.  Navigation station and settee is center starboard; to port is table with L shaped seating. Galley to port side is U shaped with double stainless sinks; two burner propane stove; top and side entry refrigerator/ freezer. Marble counter tops.  Aft cabin starboard side with double berth and small hanging locker.  Engine located under companion way stairs. Interior finished in teak.
Fresh water pressure is provided by a 12v pump and hot water is provided by a 110/engine heated water heater. Additional fresh and salt water manual pumps at galley sink. Manual fresh water pump at head sink.

COMMUNICATIONS AND NAVIGATION

VHF: ICOM M602 with mic (plus RAM mic not installed). Chart plotter: Raymarine E80. SSB/HAM: ICOM M802 with dual ground plates on hull. Tuner: ICOM AT-140. Modem: Pactor III. Autopilot: North Star AP-380. Radar: Raymarine ST60 with self-leveling mast mount. Compass: Richie 5 inch and Asmith KVH digital. Depth Sounder: ST60 and DSM 300 digital sounder. Knot meter/log: ST60. Radar reflector: Yes. Stereo: Kenwood cd/cassette. Lights: 12v Cabin (LED); Navigation: Steaming; Deck; and Anchor. Inverter: 700wt West Marine. Battery charger: ProMariner 60 amp. Electronic protection: Fuse and Circuit Breakers. Location: Nav Center.

GROUND TACKLE

Anchor windlass: Maxwell HWC 11000 12V with dual up controls. Primary anchor: 25kg Rocna with 300′ 5/16 HT chain and 250ft 5/8 rode. Secondary anchor: 20 KG Bruce with 100ft 5/16 HT chain and 350ft rode. Additional anchors: Danforth 20lb with chain and rode; Fortress FX55: ParaTec sea anchor. Fenders: 10. Dock Lines: Adequate.

OTHER EQUIPMENT AND SYSTEMS

Refrigerator/freezer: Adler Barbor Super Cold Machine 12V compressor w/ evaporator. Stove: Force 10, two-burner. Watermaker: Spectra 150. Dingy: AB 8.5ft RIB (never in water). Outboard: Nissan 8hp 4-stroke. Canvas: Dodger; full deck cover; cockpit cushions. BBQ: Dickenson Bar-B- Que with own rail mounted 10 lb. propane tank. Canvas cover. Television: LG 23-inch flat screen TV/monitor. Wind Vane: Monitor.  Solar panels: one-140 watt and two-85 watt, with smart regulator. Fans: six-cabin fans. Ships clock and barometer: Wiems and Plath. Manual fuel transfer pump (from deck jugs to deck fill — no lifting at sea). Wind generator: mounted on stainless steel arch with adjustable 140 watt solar panel. Lifting davit system: seven-part B & T on rotating arm located on arch where needed to launch/replace outboard on rail and to raise/lower equipment/supplies from dinghy and swing onboard/overboard at helm seat. Boat hooks: Two. Balmar high output alternator: New spare. Whisker pole: Forespar (mast stored). Jerry cans: Six-diesel; two-water; two-gas. Steering gear: Cables from wheel to quadrant. Spare: Steering quadrant with cables and spare prop.

SAFETY EQUIPMENT AND SYSTEMS

Fire extinguishers: five-2lb ABC dry chemical. Located: Throughout boat. Flares: Orion electronic (new) and parachute and 12 Ga. Style (expired). Bilge pumps: One electric, one manual. Life sling: one approved. Jack lines. Lifejackets: two PFD inflatable w/built-in harness and four Type II . Life raft: Viking off shore 4 person. EPIRB: ACR Global. Ditch bag: yes.

TANKS

Diesel: One Fiberglass. Capacity: Total 80 Gallons. Location: In keel under cabin sole. Fill points: Deck. Vents: Overboard. Shut off: Under cabin sole. Fresh water tank: Two fiberglass; total capacity 80-gallons. Location: In keel under cabin sole. Fill points: Deck. Vented: to galley sink. Holding tank: one fiberglass. Capacity: 15-gallons. Location: In keel under cabin sole. Propane tanks: three 10-lb (two in vented locker and one rail mounted for BBQ).

SHIPS ELECTRICAL SYSTEMS

Shore power: 120V AC 30amp. Cords: Two 120V 30amp power cord (25ft each) 50ft total length; with appropriate connectors. Protection: Circuit breakers in panel at navigation station; 30A on incoming shore power. Polarity protection: An integral reverse polarity indicator is located on the main electrical panel. 120V outlets located throughout. Start battery: Lifeline AGM (2020). House Batteries: four-6V AGM golf cart type (2013). (There is available space for 6 batteries of the same type/manufacturer.) All batteries are secured. Charger: ProMariner 60amp. Ships interior/exterior lighting: 12volt lighting throughout. Engine alternator: Balmar high output 70amp with external smart regulator. Wind generator: Air-X Marine with spare blades included. Solar panels: two 85-watt solar panels and one 140-watt solar panel with controller.

MACHINERY AND FITTINGS

Main engine: Yanmar 3QM30FG 30HP marine diesel. Age: 1987. Hours: Approximately 2500 – no hour meter. Operation: Engine runs in normal operating temperatures and no signs of smoke. Appearance: Good. Cooling: Fresh and raw water. Exhaust type: Wet, routed to stern. Fuel filters: Duel Racor marine with manifold shut off valves. Fuel pump: Electric and engine. Propeller shaft: Stainless steel. Propellers: Bronze (included 1 spare). Cutlass bearing: Bronze. Stuffing Box: Tides Marine dripless with extra seals. Engine controls and instruments: Cockpit steering station bronze binnacle with cables to quadrant. Gauges: Water temp, oil pressure.

BOTTOM AND HULL

Bottom Paint: New Comex (2020). Keel: Encapsulated. Bottom: In good condition with no blisters. Rudder: Barn door, attachments good. Zincs: Prop nut. Prop: Three blade fixed coated with PropSpeed fouling release system (2020).

RIGGING AND SAILS

Mast and boom: Aluminum painted. How stepped: deck. Spreaders: Single aluminum. Standing rigging: Stainless steel wire swaged connected to stainless steel turnbuckles pined to stainless steel deck chain plates. Size and condition: More than adequate for intended use. Attachment Points: Good. Sails: Main (2 deep reef points), condition good; furling jib (yankee); spinnaker; tri- sail and stay sail. Condition: Good. UK Sails main; jib; staysail and trisail new in 2006, tanbark in color with trisail white with orange points. Dual preventers: one each port and starboard with 4- part Block & Tackle on each. Sheets and halyards: Yacht braid marine quality (2015) all routed to mast and cockpit. Winches: Two #27-Barient ST; two #24-Barient ST; three #17-Barient ST. Note: All spars, standing rigging, sails and deck hardware are more than adequate for the intended use on this vessel.

  La Vita drawing.jpg

1987 HANS CHRISTIAN CUTTER 33T
LOA: 41.0’  LOD: 32.8’  LWL: 30.0’  Beam: 11.6’  Depth: 5.5’

CONTACT
Richard and Lynn Bradshaw

EMAIL: LaVita.blog@gmail.com
US: 702-543-1814
MX Cell: 52-322-181-3267